Draining Water From Ice Cube Maker; Cleaning And Maintenance - Unold 48935 Instrucciones De Uso

DE
13. You can stop the ice production at any time by pressing the „ON/OFF"
button.
EN
14. When you have produced all the ice you need, switch off the appliance by
pressing the „ON/OFF" button and wait for approx. one minute. Remove the
FR
ice cube basket and empty it. If there is any water left in the ice cube maker,
NL
drain it off through the water outlet. For instructions, see chapter „Draining
water from ice cube maker".
IT
15. Do not leave the ice cubes in the ice cube basket , as they tend to melt
quickly. For storage, place the ice cubes in the freezer.
ES
16. After use, leave the ice cube maker open to prevent mould and bacterial
PL
growth inside the appliance.
For hygiene reasons, replace the water in the ice cube maker latest after
24 hours.

DRAINING WATER FROM ICE CUBE MAKER

1. To drain off water from the appliance, proceed as follows:
Switch off the appliance and disconnect the plug from the power socket.
2. Hold the device above a large bowl or the kitchen sink.
3. Remove the cap from the water outlet (6) near the front at the bottom of
the appliance.
4. Let all water drain off, and then close the outlet again.
5. Avoid tilting the ice cube maker, as the compressor might otherwise be
damaged.

CLEANING AND MAINTENANCE

Before cleaning the appliance, switch it off and disconnect the plug from
the power socket.
1. To clean the appliance or the power cord, never immerse it in water or
another liquid. Do not clean the ice cube maker in the dish washer.
2. Clean the ice cube maker with a damp cloth. The ice cube basket can be
cleaned with warm water and washing-up liquid.
3. If necessary, clean the water tank with a damp cloth.
28 von 96 Stand 25.1.2021