Makita JS3201 Manual De Instrucciones página 6

OPERATION
CAUTION:
When cutting, always place the shear on the
•
workpiece so that the material cut away is
positioned on the right side to the operator.
Hold the tool firmly with one hand on the main
•
handle when performing the tool.
Holding material
013366
The materials for cutting should be fastened to the
workbench by means of workholders.
Shearing method
013367
For smooth cuts, tip the tool slightly backward while
advancing it.
Maximum cutting width
A
1800 mm
1
004703
Stay within the specified maximum cutting width (A):
Case of length 1,800 mm (70-7/8").
Mild steel (thickness) 3.2 mm (10 ga)
Max. cutting width (A) 90 mm (3-1/2")
Stainless (thickness) 2.5 mm (13 ga)
Max. cutting width (A) 70 mm (2-3/4")
006431
1. Workholder
1
1. Cutting line
(70-7/8")
Under 2.3 mm (14 ga)
No limit
Under 2.0 mm (15 ga)
No limit
Minimum cutting radius
Minimum cutting radius is 50 mm (2") when cutting 2.3
mm (14 ga.) mild steel.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
The tool and its air vents have to be kept clean.
Regularly clean the tool's air vents or whenever the
vents start to become obstructed.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
2
013361
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
6
1. Limit mark
1
1. Screwdriver
2. Brush holder
cap
1