Ironing With Steam - BEAUTURAL 724NA-0001 Manual De Instrucciones

3. The digital display will show the
EN
setting number and fabric type. The
DE
fabric type will flash on the display
FR
until the set temperature is reached.
ES
IT
4. When your set temperature is reached, the iron will beep once
and the fabric type will stop flashing.
5. To change temperature settings while ironing, just press the
Temperature Setting button. When a lower setting is selected,
fabric type will flash until the iron temperature has lowered to the
correct level for that setting.
LCD Display
Normal Status
Standby Mode Level 1 - Acrylic
Level 4 - Polyester Level 5 - Blended
Level 8 - Jeans Level 9 - Linen
Temperature
mark
Fabric type
Level 2 - Nylon Level 3 - Silk
Level 6 - Wool Level 7 - Cotton
Auto Shutoff
05
Error Status
NTC short-circuit NTC lower than 50°C
• Unplug the iron from the power when the LCD panel shows an error
status. Plug the iron in again once the soleplate has cooled.
• If the LCD panel still shows an error status, contact qualified techni-
cians to check and repair the iron or contact our customer service.
Note: NTC stands for Negative Temperature Coefficient.

Ironing with Steam

1. For steam ironing, make sure the water tank is filled to Max.
2. Toggle the Variable Steam knob to the appropriate steam setting for
your fabric.
Note: See the fabric guide on the LCD display and read the
garment's label to help you determine which steam setting to use.
3. For optimum performance when using steam, stand the iron on its
heel rest until the selected temperature setting is reached.
4. When finished ironing, toggle the Variable Steam knob off
Note: Ironing with steam is only possible when temperature setting is
between level 6 to level 9. Level 1 to level 5 are for dry ironing
only.
Steam Burst
Horizontal
Tip: Use to remove stubborn creases.
1. With the water tank filled to the Max level, set the temperature setting
and Variable Steam knob to the appropriate settings for your fabric.
See the fabric guide on the LCD display and read the garment's label
to help you determine which steam setting to use.
2. For best performance, press the Steam Burst button at 5-second intervals.
3. When finished ironing, toggle the Variable Steam knob off
the iron on its heel and unplug the iron.
Note: Ironing with steam is only possible when temperature setting is
between level 6 to level 9. Level 1 to level 5 are for dry ironing only.
Soleplate over 270°C±15°C
.
, stand
06
EN
DE
FR
ES
IT