Power Source - Nevir NVR-800VMUC Manual De Instrucciones

15. Stop/USB/Card Button
REMOTE CONTROL UNIT
1. PLAY/PAUSE BUTTON
2. RECORD BUTTON
3. STOP/USB/SD BUTTON
4. SKIP- BUTTON
5. SKIP+ BUTTON
6. DISPLAY BUTTON
7. PROG BUTTON
8. MODE BUTTON
9. FOLDER UP BUTTON
10. FOLDER DOWN BUTTON
11. DELETE BUTTON
Avoid installing the unit in locations described below:
• Places exposed to direct sunlight or close to heat radiating appliances such as electric
heaters.
• Dusty, humid or moist places.
• Places subject to constant vibration.
This system is equipped with non-skid rubber 'feet' to prevent the product from moving when you
operate the controls. These 'feet' are made from non-migrating rubber material specially formulated
to avoid leaving any marks or stains on your furniture. However certain types of oil based furniture
polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet' to soften, and leave
marks or a rubber residue on the furniture.
To prevent any damage to your furniture we strongly recommend that you purchase small self-
adhesive felt pads, available at hardware stores and home improvement centers everywhere, and
apply these pads to the bottom of the rubber 'feet' before you place the product on fine wooden
furniture.
This Unit is designed to only operate on normal 230V~ 50Hz household power. Do not
attempt to operate the System using any other power source. You could cause damage to
the unit and void your warranty.
30. AC Power Cord
IMPORTANT NOTES
PROTECT YOUR FURNITURE!!

POWER SOURCE

2