Activating The Remote Control; Using The Remote Control Correctly - Nevir NVR-800VMUC Manual De Instrucciones

The remote control unit operates on 1 CR2025 Lithium battery (Included).
1. Plug the AC POWER CORD into a 230V AC ~ 50Hz
2. Turn the System on by sliding the Function Selector (12) to either "TUNER", "USB/SD"
or "PHONO". The LCD backlight will turn on.
Mains plug should be regularly checked for any damage. If it is damaged do not operate
the unit, seek advice from a qualified service technician or contact the distributor of this
product via the telephone number at the back of this instruction manual.
Do not attempt to operate the unit on any other power source as this could cause damage
to the unit and void your warranty.
Remarks:
If there is a malfunction due to electrostatic discharge (ESD), reset the unit by unplugging
the AC CORD from the outlet, wait 30 seconds and then plug the AC CORD in again to
reset to normal operation.
Remove the plastic insulator tag sticking out of the Battery Compartment of the Remote
Control by pulling on it. Once the tag is removed, the Remote Control will be ready for use.
BATTERY CARE
i. If the unit is not to be used for an extended period of time, remove the battery. An old or
leaking battery can cause damage to the Remote Control.
ii. Do not dispose of batteries in fire, batteries may explode or leak.
BATTERY REPLACEMENT
When the battery becomes weak, the operating distance of the
Remote Control is greatly reduced and you will need to replace the
Lithium battery.
1. Remove the battery compartment from bottom of the Remote
Control.
2. Install 1 "CR2025" Lithium battery with the positive side facing up.
3. Replace the battery compartment.
IMPORTANT: Be sure that the battery is installed correctly. Wrong polarity may damage the
Remote Control and void the warranty.
Note: The Remote Control is only for operating the USB and MMC Card functions.

Point the Remote Control at the SENSOR (IR) located on the front of the System.

The functions of the remote buttons are the same as the corresponding controls on the
main unit.

The performance of the infrared SENSOR may be degraded causing unreliable
operation if there is a strong ambient light source in the same room.
AC OPERATION

ACTIVATING THE REMOTE CONTROL

USING THE REMOTE CONTROL CORRECTLY

3