Ending The Training; Information; Important Information - Sigma iD.GO Manual De Instrucciones

2.3 Training time
(start, stop, reset)
The stopwatch is reset to zero.

2.4 Ending the training

Stop the stopwatch by pressing the top button
and remove the chest belt.
After a short time, the iD.GO will automatically
return to the sleep mode.
The iD.GO is in sleep mode.
The previous training time can be recalled by
pressing the top button.
To delete the previous training time,
see section 2.3.
24

Information

3

3.1 Important information

If no heart rate frequency can be read on the display, this may be the result of
the following:
– The chest belt with transmitter is not worn properly.
– The inside surfaces of the conductive ribbed rubber pads are not clean
or not moist.
– Disturbance exists from electrical interference sources
(high-voltage cables, railway lines etc).
– Transmitter battery (CR 2032) is empty (ref. no. 00342).
Please consult your doctor before starting training – especially if you suffer
from any cardiovascular illnesses.
25