Replacing The Battery - Bushnell ENRAGE Manual Del Propietário

Be sure they are properly installed and securely fastened according to the
manufacturer's instructions for your safety. There is no set eye relief for your AR
Optics; therefore, you should provide at least three inches of clearance between
the eyebell and your eye when in the shooting position.
2. Set the ring onto the base or bases so that they align with the crosscut grooves.
Work the ring into the base until the crossbolt seats into the groove. Securely
tighten the locking nut with a coin or screwdriver.

REPLACING THE BATTERY

Should your reticle grow dim or not light at all, you will
need to replace the battery. To install a new battery,
unscrew the battery compartment cover and insert a new
CR2032 battery, with the "+" side facing up as shown (right).
Replace battery cover.
WARNING! : Since this procedure involves live fire, it should be done at an approved
range or other safe area. Check bore for obstructions. An obstructed bore may cause
injury to you and others near by. Eye & Ear protection is recommended.
USING YOUR AR OPTICS
1. Activate the illuminated dot by turning the rheostat knob clockwise to brighten
and counterclockwise to dim. With the "1" lined up with the index mark, the dot
will be the dimmest, and with a setting of "8", the brightest illumination level.
To switch off the sight, select a dot mark between any two numbers.
®
SIGHT
5