Battery Charging - Ac Connections; Assembly Instructions; Mounting Instructions - DSR Industrial Serie Manual Del Usuario

7.4 Position yourself and the free end of the cable you previously attached to
the NEGATIVE (NEG, N, -) battery post as far away from the battery as
possible – then connect the NEGATIVE (BLACK) charger clip to the free
end of the cable.
7.5
Do not face the battery when making the final connection.
7.6 When disconnecting the charger, always do so in the reverse order of the
connecting procedure and break the first connection while as far away
from the battery as practical.
7.7 A marine (boat) battery must be removed and charged on shore. To
charge it onboard requires equipment specially designed for marine use.
8. BATTERY CHARGING – AC CONNECTIONS
8.1 This battery charger is for use on a nominal 120-volt
circuit and has a grounded plug that looks like the
plug illustrated. The charger must be grounded to
reduce the risk of electric shock. The plug must be
plugged into an outlet that is properly installed and
grounded in accordance with all local codes and ordi-
nances. The plug pins must fit the receptacle (outlet).
Do not use with an ungrounded system.
DANGER – Never alter AC cord or plug provided – if it does not fit the
outlet, have proper grounded outlet installed by a qualified electrician. Im-
proper connection can result in a risk of an electric shock or electrocution.
NOTE: The use of an adapter plug is not recommended.
8.2 Recommended minimum AWG size for extension cord:
• 100 feet long or less - use an 14 gauge extension cord.
• Over 100 feet long - use a 12 gauge extension cord.
9.

ASSEMBLY INSTRUCTIONS

No assembly required
10.

MOUNTING INSTRUCTIONS

To mount the charger to a wall or other flat surface:
10.1
Remove the two screws from one side of the unit near the back.
10.2 Attach a mounting bracket, with the keyhole towards the top, using the
screws you just removed.
10.3 Repeat for the other side. Note: Completely install one bracket before
moving to the next.
5
• •