Control Panel - DSR Industrial Serie Manual Del Usuario

10.4 Using the charger as a template, install two #10 panhead screw anchors
(or equivalent) into the wall you want to mount the charger to. Leave the
heads of the screws extended 1/16" away from the surface. The mount-
ing brackets are designed to match the 16" wall stud spacing commonly
found in wood and steel framed buildings, for increased support install the
anchors into the wall studs. NOTE: Make sure the screw/anchor combina-
tion installed into the wall is able to support up to fifty pounds of weight.
10.5
Position the charger, with the mounting brackets installed, so that the key-
hole slots on the mounting brackets line up with both screws you installed.
Then slide the charger down so that the screw heads lock in the keyhole
slot of the mounting brackets.
11.

CONTROL PANEL

6
• •