Assembly And Operation; Applications; Removal And Installation Method Of Battery; Charging Method - Hitachi DS 14DSL Manual De Instrucciones

English

APPLICATIONS

<DV14DSL, DV18DSL>
Use as a hammer drill
Drilling of soft bricks and concrete blocks.
<DS14DSL, DS18DSL, DV14DSL, DV18DSL>
Use as a drill
Drilling of soft steel, wood, plastic and aluminum
materials.
Use as a screwdriver
Tightening and loosening of machine screws, wood
screws and tapping screws.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (See Fig. 3).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 3).
Insert
Pull out
Rechargeable
battery

CHARGING METHOD

NOTE:
Before plugging into the receptacle, make sure the
following points.
The power source voltage is stated on the
nameplate.
The cord is not damaged.
12

ASSEMBLY AND OPERATION

Handle
Latch
push
Fig. 3
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn up.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical cord if
damaged. Have it repaired
immediately.
2. Insert the battery into the charger.
Firmly insert the battery into the charger until the
line is visible, as shown in Fig. 4 .
Pilot lamp
Line
<BSL1430>
Rechargeable
battery
Charger
Line
<BSL1830>
Fig. 4