Assembly And Operation; Applications; Prior To Operation - Hitachi W 6VM Manual De Instrucciones E Instrucciones De Seguridad

English

ASSEMBLY AND OPERATION

APPLICATIONS

Tightening hex. head screws
Tightening Drywall screws, wood screws and self-drilling screws
NOTE:
For tightening the Self-drilling screws, sub-stopper (B) and non-magnetic bit holder
(sold separately) are recommended.

PRIOR TO OPERATION

1. Power source
Ensure that the power source to be utilized conforms to the power source re-
quirements specified on the product nameplate.
2. Power switch
Ensure that the switch is in the OFF position. If the plug is connected to a recep-
tacle while the switch is in the ON position, the power tool will start operating
immediately and can cause serious injury.
3. Extension cord
When the work area is far away from the power source, use an extension cord of
sufficient thickness and rated capacity. The extension cord should be kept as
short as practicable.
4. Check the receptacle
If the receptacle only loosely accepts the plug, the receptacle must be repaired.
Contact a licensed electrician to make appropriate repairs.
If such a fautly receptacle is used, it may cause overheating, resulting in a seri-
ous hazard.
5. Confirming condition of the environment
Confirm that the work site is placed under appropriate conditions conforming to
prescribed precautions.
8
WARNING:
Damaged cord must be replaced or repaired.