Filling The Water Reservoir; Dry Ironing - Sunbeam 3982 Manual De Instrucciones

F
ILLING THE
You must fill the water reservoir with water to use the SPRAY MIST
steam out of your iron.
TIP: Sunbeam tests each iron at the factory to ensure that they function correctly. The test
may leave a small, harmless amount of water within the water reservoir. Before you
fill the water reservoir, please consider the following:
• While this iron was designed for use with tap water, very hard water will reduce the
performance of the iron. If your water is very hard, Sunbeam recommends that you use
tap water the first time, then consider using demineralized or distilled water for
subsequent use. You should use tap water once a month, however, to maintain the iron's
optimal steam performance.
• Do not use water that has passed through a home water softening system. This type
of water contains minerals that will decrease the performance and shorten the life of your
iron. Use demineralized or distilled water, instead.
IMPORTANT: When not ironing, always set the Steam dial to Dry/O and
the Fabric/Temperature dial to Off/O.
T F
O ILL THE
1. Make sure the iron is UNPLUGGED and that the large Fabric/Temperature dial
is set to Off/O and the small Steam dial is set to Dry/O.
2. Hold the iron at an angle.
3. Fill the water reservoir with tap water until it reaches the maximum fill level.
WARNING: To prevent the risk of burns, be careful when filling a hot iron with water.
Hot metal parts, hot water and steam can cause injuries.
D I
RY RONING
1. Make sure the Steam dial is turned to the Dry/O setting.
2. Plug the cord into a 120-Volt AC outlet.
3. Turn the large Fabric/Temperature dial to the fabric setting you desire (Silk or Synthetics).
Allow the iron to heat for 2 minutes. While the iron is heating, make sure it is sitting on
its heel rest on a stable, protected surface.
TIP: Refer to the Ironing Guide on Page 7 for the recommended setting for your fabric.
W R
ATER ESERVOIR
W R
ATER
English-3
ESERVOIR
®
feature and to get