Filling The Water Reservoir - Sunbeam EURO PRESS 4041 Manual De Instrucciones

your iron

Filling the Water Reservoir

You must fill the water reservoir with water to use
the SHOT OF STEAM
and to get steam out of your iron.
Tip: SUNBEAM
ensure that they function correctly. The test may
leave a small, harmless amount of water within
the water reservoir.
Before you fill the water reservoir, please consider
the following:
• While this iron was designed for use with tap water,
very hard water will reduce the performance of
the iron. If your water is very hard, SUNBEAM
recommends that you use tap water the first time,
then consider using demineralized or distilled water
for subsequent use. You should use tap water once
a month, however, to maintain the iron's optimal
steam performance.
• Do not use water that has passed through a home
water softening system. This type of water contains
minerals that will decrease the performance and
shorten the life of your iron. Use demineralized
or distilled water, instead.
Important: When not ironing, always set the Steam
Dial to ZERO and the Fabric Select Dial to MIN.
To fill the water reservoir:
1. Make sure the iron is unplugged. Set the Steam
Dial to ZERO and the Fabric Select Dial to MIN.
2. Fill water cup with water. Pour water into iron
water reservoir. Do not fill water reservoir
beyond maximum fill level.
W : To prevent the risk of burns, be careful
ARNING
when filling a hot iron with water.
Hot metal parts, hot water and
steam can cause injuries.
® and SPRAY MIST
®
tests each iron at the factory to
® features
®
5