Archos DVR STATION Manual De Usuario página 17

nd
2 Test: changing channels on your tuner
After you select " " at the end of the 1
Yes
parameters so that the ARCHOS can change channels on your tuner (for a scheduled recording).
1. For the " " parameter, select the highest channel that is currently memorized on your tuner.
Channel
2. Select the "
Test channel select
attempt to switch your tuner to the selected channel. After a few seconds, your ARCHOS will ask you if the
device responded correctly:
If this worked, select "
Yes
If this did not work, select "
selected channel, using a different option*. Repeat this operation until it works.
*Here is a description of the different parameters it will use. These parameters can be set manually as well:
"Key Delay": delay between the emission of each digit of a channel ("
-
"Key: Enter": Set to "
On
-
after you enter the channel number. Example: If you normally press 1, 3, "
this parameter is set to "
"Key: -/--": Set to "
On
-
entering a channel with several digit numbers (that is to say a channel greater than 9). This key is often
represented with this symbol: "
"Switches on with": see below.
-
"Time until video": see below.
-
If the ARCHOS did not manage to switch your tuner to the selected channel, you can try using different ON/OFF codes
(see: 1 st Test: turning your tuner off) and do the 2
3. After you selected " " at the end of the 2
Yes
two parameters:
st test, the following screen appears. It allows you to correctly set the
" button. Make sure that your tuner is on. Your ARCHOS device will then
".
". Your device will try again to switch your tuner to the
No, try next option
" if normally, you have to press an "
".
On
" if normally, you need to press a special key on your tuner's remote control before
".
-/--
nd test again.
nd step, the following screen appears. You will have to set these
USER MANUAL - version 1
", " ", "
Short Normal Long
" button on your turner's remote control
OK
" to access channel 13, then
OK
").
15