Intended Use - Bosch GPLL5 Instrucciones De Funcionamiento

The tool is intended for determining and indicating exact
horizontal and vertical lines. It is also suitable for checking
plumb lines and horizontal partitions or surfaces.
The tool is suitable exclusively for operation in enclosed
Use only alkali-manganese batteries.
To open the battery lid 11, press the latch 10 in the direction of
the arrow and remove the battery lid. Insert the batteries
provided. Pay attention to the correct polarity of the batteries
according to the representation in the battery compartment.
Always replace all batteries at the same time. Only use batteries
from one brand and with the identical capacity.
• Remove the batteries from the tool when not using
it for extended periods. When storing for extended periods,
the batteries can corrode and discharge themselves.
The numbering of the product features shown refers to the
illustration of the tool on the graphic page.
1 Wall holder
2 Pin
3 Metal plate of the wall holder
4 Adhesive tape strip*
5 Belt clip
6 Spirit level for vertical alignment
7 Spirit level for horizontal alignment
8 Aluminium supporting surface
9 Exit opening for laser beam
10 Latch of battery lid
11 Battery lid
12 Supporting points
13 Laser warning label
14 Magnets
15 On/Off switch
* Accessories shown or described are not part of the
standard delivery.

Intended Use

working sites.
Preparation
Inserting/Replacing the Battery
Features
-9-