Waeco PerfectView M70IP Instrucciones De Montaje página 35

PerfectView M70IP
z Check beforehand that there is sufficient space on the other side for the drill head to
come out (fig. 2, page 4).
z Bear in mind the weight of the monitor. Provide reinforcement if necessary (larger
washers or plates).
z Make sure you can lay the connection cable to the monitor.
Choosing the installation location (fig. b, page 7)
➤ Slide the monitor (1) onto the monitor bracket (2) and secure it with the knurled
screw (3).
➤ Position the monitor with the attached monitor bracket provisionally.
➤ Mark the outlines of the corners of the monitor bracket (2) on the dashboard.
➤ Unscrew the monitor from the monitor holder.
I
NOTE
You can fasten the monitor bracket using adhesive or screws.
Sticking the monitor bracket onto the dashboard (fig. c A, page 7)
➤ Remove the film from under the monitor bracket.
➤ Stick the monitor bracket to the position of your choice.
Screwing the monitor bracket onto the dashboard (fig. c B, page 7)
➤ Hold the monitor bracket within the outlines marked beforehand.
➤ Mark four drilling points.
➤ Drill the holes, with ∅ of 2 mm, at each of the markings.
➤ Screw the monitor holder on using 4 x 20 mm self-tapping screws.
Fastening the monitor
➤ Set the monitor on the monitor bracket and secure it with the knurled nut (fig. b,
page 7).
EN
Installing the LCD monitor
35