Volume Setting - Waeco PerfectView M70IP Instrucciones De Montaje

Using the LCD monitor
Setting the video source (fig. 0, page 6)
8.5
➤ If you would like to switch to a different video source, press the "S" button (2).
✓ The monitor changes the camera in the order "Camera 1 – Camera 2 – Camera 3".
➤ If you want to have the cameras run through automatically, press the "M" button (3)
four times to open the "Auto Scan" menu.
✓ The "Auto Scan" parameter is displayed at the top in the menu.
➤ Use the "–" (5) and "+" (6) buttons to select the desired operating mode:
✓ The monitor changes the cameras in the order "Camera 1 – Camera 2 – Camera 3"
automatically in the preset scan time.
➤ If you want to set the display time (1 s to 90 s), press the "M" button (3) four times to
open the "Auto Scan" menu.
➤ Press the "V" key (4) to select the "Scan time" parameter.
➤ Press the "–" button (5) to reduce the camera display time.
➤ Press the "+" button (6) to increase the camera display time.
➤ To stop the automatic function, open the Auto Scan menu (see above) and select
the operating mode "Off".
8.6

Volume setting

To set the volume, proceed as follows:
➤ Press the "M" button (3) to open the "Screen" menu.
➤ Press the "V" key (4) to select the "Volume" parameter.
➤ Use the "–" (5) and "+" (6) buttons to select the desired volume.
40
PerfectView M70IP
EN