Remote Control - Yamaha MCS-1330 Manual De Instrucciones

TROUBLESHOOTING
■ General (continuous from previous page)
Problem
No sound or
distorted sound
Not linked with the
receiver
■ Disc
Problem
Disc playback does
not start.
■ USB
Problem
"NO USB" appears in
the display.
"OVER CURENT"
appears in the
display.
The USB device
cannot be
recognized.
"NOT SUPPORT"
appears in the
display.

Remote control

Problem
The remote control
does not work nor
function properly.
22
En
Cause
The sampling rate of a MP3 or WMA file
may not be compatible with the CD player.
The system control cable is disconnected
from the system connector jack of the
receiver and/or the CD player.
Cause
You may use a CD-R/RW that is not
finalized.
The disc label may not be facing up.
The disc may be defective.
MP3/WMA disc may not contain
sufficient music tracks to be played back.
The sampling rate of a MP3 or WMA file
may not be compatible with the CD
player.
Cause
The USB device is not connected.
The connected USB device not playable
on this system.
The connected USB device diagonally.
Check that the USB device is connected
correctly.
The connected the USB device is not
supported on this system.
Cause
The remote control may be operated
outside its operation range.
The remote control sensor on this system
may be exposed to direct sunlight or
lightening (invented fluorescent lamps).
The battery may be worn out.
There are obstacles between the sensor of
this system and the remote control.
Remedy
Check the sampling rate and bit rate of an MP3 or
WMA file are compatible with the CD player.
Connect the receiver and the CD player with the
system control cable firmly.
Remedy
Finalize the CD-R/RW.
Check that the disc label is facing up.
Try to play back another disc. If the same problem
does not happen, the disc you want to play back is
defective.
Check that your MP3/WMA disc contains at least 5
MP3/WMA music files.
Check the sampling rate and bit rate of an MP3 or
WMA file are compatible with the CD player.
Remedy
Connect playable USB device.
Disconnect the USB device. Change input source
other than USB and select USB an input source
again. Then connect playable USB device again.
Connect the USB device firmly.
Connect a supported USB device.
Remedy
For information on the remote control operation
range, refer to "Using the remote control".
Change the lighting or orientation of this system.
Replace the battery with new one.
Remove the obstacles.
See
page
23
9
See
page
—
—
—
—
23
See
page
11
—
11
11
See
page
8
8
8
8