Maintenance And Cleaning; Control And Display - RSLAB 4C Manual De Instrucciones

The RSLAB-4NC y RSLAB-4C includes the following items:
- Main unit 1 unit
- Temp. sensor PT1000 1 unit
- Kit for sensor PT1000 1 unit
4- TRIAL RUN
Make sure the required operating voltage and power supply voltage match.
Ensure the socket must be earthed reliably.
Ensure the power is off.
Plug in the power cable, ensure the power be on and begin initializing.
Add the medium into the vessel with a stirring bar.
Put the vessel on the work plate.
Set the rated stirring speed and begin.
Observe the stirring bar and LCD display.
Set the rated temperature and start heating.
Observe the real temperature on LCD display.
Stop the heating and stirring functions.
If these operations above are normal, the device is ready to operate. If these operations
are not normal, the device may be damaged during transportation, please contact manu-
facturer for technical support.

5- CONTROL AND DISPLAY

a) Control elements
1. LCD display
2. LED heat display
3. LED stir display
1
4. Heating knob
5. Stirring knob
6
6. Switch ON/OFF
7. Safe Temperature Button
Instruction manual 50694130
ENGLISH
- Stirrer bar 1 unit
- Power cable 1 unit
- User manual 1 unit
2
3
7
4
5
Pag. 16 Version 1 August 2015

11- MAINTENANCE AND CLEANING

Warning! Cut off power when maintenance and cleaning
Proper maintenance can keep instruments working in a good state and lengthen its lifetime.
Do not spray cleanser into the instrument when cleaning.
Unplug the power line when cleaning.
Only use recommended cleaners:
- Dyes: isopropyl alcohol
- Construction materials: water containing tenside / Isopropyl alcohol
- Cosmetics: water containing tenside / Isopropyl alcohol
- Foodstuffs: water containing tenside
- Fuels: water containing tenside
Wear proper protective gloves during cleaning of the instrument.
Before using other method for cleaning or decontamination, the user must ascertain
with the manufacturer that this method does no destroy the instrument.
Unit should be clean and fitted in the original packing or a suitable packing for trans-
port.
The enamel makes the heating plate easier to care for and more resistant to acids and
bases. Because of it, however, the heating plate is also more susceptible to extreme fluc-
tuations in temperature and the force of impact. This can result in cracks forming or the
coating flaking off.
12- ASSOCIATE STANDARDS AND REGULATIONS
Construction in accordance with the following safety standards:
- EN 61010-1
- UL 3101-1
- CAN/CSA C22.2 (1010-1)
- EN 61010-2-10
Construction in accordance with the following EMC standards:
- EN 61326-1
Associated EU guidelines:
- EMC guidelines: 89/336/EWG
- Instrument guidelines: 73/023/EWG
Instruction manual 50694130
ENGLISH
Pag. 21 Version 1 August 2015