Operation - Beurer Janosch JBY 93 Instrucciones De Uso

If the baby unit is used independently of the mains, the power LED begins
to flicker when the battery is low. Moreover, a beep sounds as a warning on
the parent unit every 4 seconds.
When the battery in the parent unit is low, the unit's power LED flashes
and the unit beeps every 4 seconds. If the devices are not connected to a
socket, they will switch off automatically after a short period.
If the devices are operated using the power supply unit and there is a power
cut, the parent unit switches to battery operation. For this reason, the
standby time is dependent on the battery charge status.
If no batteries were inserted in the baby unit, it switches off in the
event of a power cut and there is an acoustic warning on parent
unit.
discharging the parent unit
The battery should be discharged after being charged 300 times.
To do so, leave the unit switched on until it switches itself off
automatically.
7

operation

1. Position the baby unit so that it is in an elevated position and is not in
proximity to any other devices that may cause interference. Switch the
baby unit on with the POWER/VOL button. The power LED of the baby
unit lights up.
2. Fasten the parent unit to your arm or position it in the room in which you
are located.
3. Switch the parent unit on with the POWER/VOL button. The power LED
of the parent unit lights up.
26