Bosch Sensixx B22L Instrucciones De Uso página 22

Problem
Loss of pressure
during ironing.
Water spots appear
on the garment
during ironing.
Water spots appear
on the garment
during use of the
"PulseSteam"
function.
The hose gets hot
during use.
Water leakage from
the boiler.
The iron does not
stop steaming after
placing it on the pad
(2).
If the above does not solve the problem, get in touch with an authorised technical service.
22
B O SC H
Possible causes
1. Steam release button has been
activated for too long a period of
time, that is, it has been pressed
too frequently.
1. May be caused by steam
condensed on the ironing board.
1. Water spots are caused by steam
condensation in the hose when
cooling down after use.
1. This is normal. It is caused by the
steam passing through the hose
during steam ironing.
1. Filter (4*) located at the side of
the appliance is loose.
1. "PulseSteam" function has been
activated by double click.
Solution
1. Use the steam release button at
intervals. This improves the ironing
result as the textiles will be steamed,
dried and ironed properly.
1. Wipe the textile cover of the ironing
board, and iron any water drops to dry
them.
1. Water drops stop coming out of the
soleplate after using the "PulseSteam"
function for some time.
1. Place the hose on the opposite side so
that you cannot touch the hose during
ironing.
1. Tighten up the filter.
1. Just press the trigger once again and
the iron will stop steaming at once.
* Model dependent