Troubleshooting Guide; Cleaning And Maintenance - essentiel b ECHS 2000VH Instrucciones De Uso

When you have finished
1. When you have finished, press the
continues for 15 seconds to allow the appliance to cool down. The ventilation countdown
appears on screen, after which the appliance automatically stops at the end of the
countdown.
Note: if you leave the appliance in standby mode, it will operate in accordance with the last
settings made when it is restarted.
2. When the appliance is turned off, set the switch on the back of the appliance to 0 (power
off) and unplug the appliance.
Thermal safety: if the appliance overheats (e.g. if a cloth covers the appliance),
•
it automatically stops working. Uncover it before restarting it.

cleaning and maintenance

IMPORTANT:
Always unplug the power cord from the power
•
socket and allow the appliance to cool down before
cleaning or maintaining it.
Never immerse the appliance in water or any other
•
liquid.
Never use abrasive cleaning products on this
•
appliance (alcohol, solvent).
Basic cleaning
1. Use a slightly damp cloth to wipe the outside of the heater to remove dust and dirt.
2. Use a vacuum cleaner to remove dust from ventilation holes.
3. Make sure the heater is dry before unplugging it.
22
V.3.0
cleaning and maintenance
button to switch the appliance off. Ventilation
Thorough cleaning
1. Gently pull the release latches at the bottom of the air intake grille on the back of the
appliance, then remove the grille.
2. Pull out the black filter behind the grille.
3. Soak the filter in clean, clear water for a few minutes, then dry it thoroughly.
4. Clean the filter compartment with a soft, dry cloth.
5. Put the dry filter back behind the grille.
6. Put the air intake grille back on the appliance until it clicks into place.
If the appliance is not going to be used for an extended period
If you do not plan to use the appliance for an extended period:
1. Turn off and unplug the appliance.
2. Clean the appliance as described in the section above.
3. Remove the batteries from the remote control and store them with the appliance in a clean,
dry place.

troubleshooting guide

Before contacting your customer service department, please run the rudimentary checks
listed below. If you are unable to solve the problem, never attempt to repair the appliance
yourself. Please contact your retail store's customer service department.
Troubleshooting
Problem
The plug is disconnected or does not work. Plug the heater
•
into a suitable wall socket.
The appliance is turned off. Turn the on/off switch (0/I) to I
•
(on), then press the
The appliance is
There has been a power outage.
•
not working.
The fuse is blown or the circuit breaker has tripped. Replace
•
the fuse or switch on the circuit breaker.
The batteries in the remote control are worn out. Replace
•
them.
The heater is not placed on a flat surface. Always install your
The appliance is vibrating.
appliance on a flat, stable surface.
Possible cause
button.
23
V.3.0
troubleshooting guide