Remove Contents From Carton; Assembly; Add Engine Oil - Generac PRO 6712 Manual Del Operador

Have the engine inspected and repaired by a
servicing dealer if these symptoms develop:
• Hard starting or stalling after starting
• Rough idle
• Misfiring or backfiring under load
• Afterburning (backfiring)
• Black exhaust smoke or high fuel
consumption
NOTE: Maintenance, replacement, or repair of
emissions control devices and systems may
be performed by a small engine repair
establishment or individual. To be covered by
warranty, all emissions control service work
must be performed by a factory authorized
dealer. See emissions warranty for further
details.

Remove Contents from Carton

1. Open carton completely by cutting each
corner from top to bottom.
2. Remove and verify carton contents prior to
assembly. Carton contents should contain
one each of the following:
• Main Unit
• High-pressure Hose
• Siphon Hose & Filter
• Spray Gun
• Lance with Quick Connect Fitting
• Oil Bottle
• Parts Bag (includes):
– Owner's Manual
– Owner's Registration Card
– Bag of Colored Nozzles
3. Call Generac Customer Service 1-888-
436-3722 with the unit model and serial
number for any missing carton contents.
4. Record model, serial number, and date of
purchase on front cover of this manual.

Assembly

Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
Call Generac Customer Service at 1-888-436-
3722 for any assembly issues or concerns.
Please have model and serial number
available.
1. Insert color-coded nozzles in spaces
provided (Figure
4
WARNING
(000100a)
2-2).
Figure 2-2.Insert Nozzles (number may
2. Place spray gun and nozzle extension into
spray gun holder.
3. See Figure 2-3 Attach siphon tube.
Figure 2-3.Siphon Tube Location

Add Engine Oil

1. Place power washer on a flat, level
surface.
2. Clean area around oil fill and remove
orange oil fill cap/dipstick
Figure 2-4.Fill Engine Oil
3. Using oil funnel (optional), slowly pour oil
into oil fill opening. See
Recommendations.
NOTE: On some units there is more than one
oil fill location. In these instances it is only
necessary to use one of the oil fill points.
4. Check periodically until the oil level is
between "L" and "H" on the dipstick
(Figure 2-5). DO NOT OVERFILL.
Owner's Manual for Power Washer
vary)
(Figure 2-4).
Engine Oil
000265
000266
000115