Emissions Information; Remove Contents From Carton; Assembly - Generac 0068090 Manual Del Usuario

Emissions Information

The U.S. Environmental Protection Agency
(and California Air Resource Board for equip-
ment certified to CA standards) requires that
this engine comply with exhaust and evapora-
tive emission standards. Locate the emissions
compliance decal on the engine to determine
what standards the engine meets, and to
determine which emissions warranty applies.
The engine is certified to meet the applicable
emission standards on gasoline. It is important
to follow the maintenance specifications in the
Maintenance section to verify that the engine
complies with the applicable emission stan-
dards for the duration of the product's life. This
engine utilizes lean carburetion settings and
other systems to reduce emissions. Tamper-
ing with or altering the emission control sys-
tem may increase emissions and may be a
violation of Federal or California Law. Acts that
constitute tampering include but are not lim-
ited to:
• Removal or alteration of any part of the
intake, fuel, or exhaust systems.
• Altering or defeating the governor linkage
or speed-adjusting mechanism to cause
the engine to operate outside its design
parameters.
Have the engine inspected and repaired by a
servicing dealer if these symptoms develop:
• Hard starting or stalling after starting
• Rough idle
• Misfiring or backfiring under load
• Afterburning (backfiring)
• Black exhaust smoke or high fuel con-
sumption
NOTE: Maintenance, replacement, or repair
of emissions control devices and systems
may be performed by small engine repair
establishment or individual. To be covered
by warranty, all emissions control service
work must be performed by a factory
authorized dealer. See emissions warranty
for further details.

Remove Contents from Carton

1. Open carton completely by cutting each
corner from top to bottom.
2. Remove and verify carton contents prior to
assembly. Carton contents should contain
one each of the following:
• Main Unit
• Handle Assembly
• High-pressure Hose
• Spray Gun
• Lance with Quick Connect Fitting
• Oil Bottle
• Hose Hook
• Parts Bag (includes):
– 4 screws (for handle assembly)
– 4mm Allen key
– funnel
– 4 tree clips
– plastic gun holder
4
– plastic lance holder
– Owner's Manual
– Owner's Registration Card
– bag of colored nozzles
3. Call Generac Customer Service 1-888-
436-3722 with the unit model and serial
number for any missing carton contents.
4. Record model, serial number, and date of
purchase on front cover of this manual.

Assembly

WARNING
Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
Call Generac Customer Service at 1-888-436-
3722 for any assembly issues or concerns.
Please have model and serial number avail-
able.
1. See Figure 2-2. Insert handle and lock into
place.
Figure 2-2. Insert Handle
2. See Figure 2-3. Squeeze and Install hose
hook.
Figure 2-3. Install Hose Hook
Operator's Manual for Power Washer
(000100a)
000369
000370