Before Use - JB Systems Light LED ROPE LIGHT Manual De Instrucciones

ENGLISH
®
Thank you for buying this JB Systems product. To take full advantage of all possibilities and for your own safety, please
read these operating instructions very carefully before you start using this unit.
FEATURES
This product meets the requirements of the current European and national guidelines. Conformity has been established
and the relevant statements and documents have been deposited by the manufacturer.
 This device has been designed to produce decorative effect lighting and is used in light show systems.
 RGB Multicolor flexible rope light (round, D=14mm) with super bright LEDs inside.
 Perfect for indoor and outdoor multicolor façade decoration of bars, discotheques, shops, ...
 Can be bended to follow the shape of walls and corners.
 Solid 4pin connectors with security lock.
 To be used with our LED-MANAGER (dmx power supply)
 Comes in 30 m lengths that can be cut every 50cm.
 Low power consumption: 2 Watt/meter
 Power cables, middle connectors, end caps and mounting clips separately available.
Important remark : The led rope does only work in cooperation with a separate device, the LED MANAGER (to control
the rope light by DMX). It's impossible to use the led rope light separately.

BEFORE USE

 Before you start using this unit, please check if there's no transportation damage. Should there be any, do not use the
device and consult your dealer first.
 Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary for the user to
strictly follow the safety instructions and warnings in this user manual. Any damage caused by mishandling is not
subject to warranty. The dealer will not accept responsibility for any resulting defects or problems caused by
disregarding this user manual.
 Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user manual.
Check the contents:
Check that the carton contains the following items:
 Operating instructions
 30m Led rope light
INSTALLING THE LED ROPE LIGHT AND ACCESSORIES
SOME IMPORTANT REMARKS:
!! This LED RGB rope light can only be used together with the JB SYSTEMS
!!! DON'T CONNECT DIRECTLY TO 230 Vac !!!
Don't use lengths over 30m, the internal conductors will be overloaded which will damage the rope light!! (
more info below )
 With all LEDs switched on, this rope light consumes about 2 Watts/meter. This means you can connect up to 150m on
1 LED MANAGER (75m on each output: 2x 75m = 150m)
 The rope light can be cut every 50cm (cutting marks available)
 This product can be used in indoor and outdoor situations, the maximum ambient temperature is 45°C.
JB SYSTEMS
®
OPERATION MANUAL
®
LED MANAGER !!
1/25 LED ROPE LIGHT
ENGLISH
SOME ACCESSORIES EXPLAINED:
 POWER CABLE: this power cable is used to connect the rope light to the LED MANAGER. This can be done by
simply connecting the conductors of the power cable with the colored conductors of the cables delivered with the LED
MANAGER.
 MIDDLECONNECTOR:
Used to link 2 pieces of LED RGB rope light together.
 END CAP: Used to seal the end of a rope light.
 MOUNTING TRACKS (2m): Used to guide the rope light when it is installed on a flat surface. You will be come a
nicely aligned straight rope light.
JB SYSTEMS
®
OPERATION MANUAL
2/25 LED ROPE LIGHT