Tabla de contenido
Publicidad
1. ASSEMBLY INSTRUCTIONS
WARNING!
Carefully read the safety manual before using
the machine.
Before leaving the factory, every machine is
submitted to a series of tests in which everything
is thoroughly checked.
RUBI is constantly working on the development
of its machines; and therefore reserves the
right to be able to make any modifications it
feels to be appropriate, and therefore no claims
can be made on the basis of the information
and illustrations shown in this manual.
1.1 Applications
The ND-180-BL diamond blade cutter is a
technologically advanced product, suitable for
cutting ceramic materials, including especially
hard ones. Its unique operational system using
a wet blade is able to eliminate all of the dust
produced during the cutting process.
The machine is suitable for making, with a high
degree of comfort, straight, miter and special
cuts; with the major advantages in terms of
the dimensions, weight and handling of the
machine of being considered a portable product.
1.2 Assembly
Remove the machine from its packaging
and check none of the parts have been
damaged. If they have, replace them with
original spare parts. If any components need
changing, only use the manufacturer's original
spare parts, otherwise the GS Mark may no
longer be valid.
Prepare a stable surface and clear it of any
other materials for use as a surface for
supporting the machine.
1.3 Connection
Check that the nameplate ratings for the voltage
and frequency of the machine are the same
as those of the electricity supply.
The intake of current must include an earth
connection and protection against electrical
faults (Differential). When using an extension
lead, check that the wire is no thinner than
2.5 mm
2
.
In carriage, roll up the supply cable. Never pull
the wire to move the machine.
5
ENGLISH
1.4 Installing the blade
Disassemble the blade's protective casing.
Using a 8 mm spanner keep the motor axis
locked. Using a 19 mm spanner, unscrew the
lock nut from the blade flange, and position
the disk while carefully checking the direction
of its rotation.
Each tool is clearly marked with an arrow that
indicates the direction of rotation.
Now assemble the blade's protective casing.
Position the upper protective cap of the blade,
which protects the user from possibly getting
cut while working. So, when making cuts, the
cap should be adjusted depending on the
thickness of the piece to be cut.
2. INSTRUCTIONS FOR USE
WARNING!
Before beginning any cutting operation, and
while performing the same, make sure that the
water level is high enough to cover the diamond
part of the blade. Filling or refilling can be done
straight into the tank.
Periodically replace the water in the tank.
Working with clean water prolongs the useful
life of the blade and improves its performance.
Place the blade protection about half a
centimeter above the surface of the tile to be
cut and lock the blade protection by fully
pressing in the bolt.
Move spanners and other tools well away before
switching on the machine.
2.1 Using the blade
Do not use scratched or cracked diamond
blades.
Do not stop the blades using lateral pressure.
At the end of a day's work, empty the
machine of water, as prolonged immersion
can deteriorate the blade.
2.2 Flat surface cutting
Position the cutting guide and lock it by fully
pressing in the knobs.
Correct fastening of the blade will help you
make repeated and more precise cuts.
Advance at a speed that is proportional to
Publicidad
Tabla de contenido
