Johnson Controls Penn Serie Instrucciones De Instalación

P70, P72, and P170 Series Controls for Low
Pressure Applications
Installation Instructions
Applications
P70, P72, and P170 Series Controls for Low Pressure
Applications provide low-side pressure control on
commercial refrigeration and air-conditioning
applications.
IMPORTANT: Use this P70, P72, or P170 Series
Control for Low Pressure Applications only as an
operating control. Where failure or malfunction of the
P70, P72, or P170 Series Control could lead to
personal injury or property damage to the controlled
equipment or other property, additional precautions
must be designed into the control system.
Incorporate and maintain other devices, such as
supervisory or alarm systems or safety or limit
controls, intended to warn of or protect against
failure or malfunction of the P70, P72, or P170
Series Control.
P70A and P170A type models with Single-Pole Single-
Throw (SPST) Open-Low switch action are the most
popular models and are typically used for Open-Low
operation and pump-down control. See Table 1 through
Table 4.
P70 and P170 Series control models are also available
with SPST Open-High switch action and are typically
used for capacity control. See Table 3 and Table 4.
Control models with Single-Pole Double-Throw (SPDT)
or 4-wire, 2-circuit switch action allow users to install
alarm devices or other control circuits. See Table 4.
Table 1: Standard P70, P72 and P170 MICRO-SET® Control Models for Low Pressure Applications (for
Non-corrosive Refrigerants)
Model Switch Action
Number
P70AB-12 SPST
Open-Low
P170AB-12
Refer to the
Range
in. Hg to psig
(kPa)
12 in. Hg to 80 psig
(-41 to 551 kPa)
P70, P72, and P170 Series Controls for Low Pressure Applications Installation
QuickLIT Web site for the most up-to-date version of this document.
P72 Series control models have a Double-Pole Single-
Throw (DPST) switch with load-carrying contacts that
provide direct control of 208/240 VAC single-phase
motors up to 3 hp, 480 VAC single-phase,
non-compressor motors, and 208/220 VAC 3-phase
motors up to 5 hp. See Table 4.
These controls are available in several pressure
ranges and are compatible with most common
refrigerants. They may also be used on air, water,
and other non-corrosive fluid applications.
Ammonia-compatible models are also available. See
Table 3.
The MICRO-SET® option provides fine adjustment of
the differential setting for precision pressure control of
critical low pressure applications.
Some models feature Limited Knob Adjustment, which
restricts adjustment of the pressure settings and deters
overadjustment or tampering. See Limited Knob
Adjustment.
The Manual Reset Lockout mechanism does not allow
the control to automatically reset after the control has
Cutout, providing shutdown capability for unmonitored
equipment. See Manual Reset Operation.
NEMA 1 enclosures are standard on most models.
NEMA 3R enclosures are available on select models.
Table 1 through Table 4 list the standard models and
features of P70, P72, and P170 controls for low
pressure applications. These standard models are
available through most authorized
Johnson Controls/PENN® distributors.
Differential Pressure
psi (kPa) Connection
Minimum 5 (34) 36 in. Cap. with
Maximum 35 (241) 1/4 in. Flare Nut
1/4 in. Male Flare
Connector
Part No. 24-7664-1601, Rev. G
Issued March 2016
Maximum
Overpressure
psig (kPa)
325
(2,241)
Instructions
1