JENN-AIR JXT8030ADS Guia De Instalacion página 8

DUCTLESS CONVERSION
Ductless conversion is intended for applications where an exhaust duct work is not possible to be
installed. When converted, the hood functions as a "purifying" hood rather than an exhaust hood.
Fumes and exhaust from cooking is drawn and filtered by a set of optional Carbon Filters. The air
is then purified and re-circulated back within the home.
We recommend to ALWAYS exhaust air outside of the home by employing existing or installing
new duct work, if possible. The hood is most effective and efficient as an Exhaust unit. Only when
the exhaust option is not possible should you recourse to converting the hood into a "purifying"unit.
When converted to be a "purifying" unit, a set of Carbon Filters are required on top of its standard
Metal Filter set. Order according to its Part number below. The standard Metal Filters are intended
to capture residue from cooking and the optional Carbon Filters help to purify fumes exhausted
from cooking for re-circulation.
Carbon Filters (Required)
1. Purchase ductless Carbon Filters as follows:
Hood Model: Part No.
JXT8030ADS JFLTRC8030
JXT8036ADS JFLTRC8036
JXT8042ADS JFLTRC8036
2. Remove metal filters on hood. Clip
carbon filters onto each slot opening.
3. Re-install metal filters.
4. Set filter change reminder for carbon filters.
When Off, hold for approx. 5 seconds.
The display will change from
(exhaust mode) to , (purifying mode/
carbon filters used) this indicates that the
elapse timer function is switched on and
Carbon Filters are used.
5. Carbon Filters must be replaced after
every 120 hours of use (or approximately
every 2 to 3 months based on the average
of 1-2 hrs. of daily cooking time). The
microprocessor in the controls when set,
will count usage time and indicate when
carbon filter replacement is required.
6" straight pipe
Ducting
1. Install a 6" straight pipe and a "T" connector/
or a 90 elbow to divert air through louvers on
duct cover.
INSTALLATION
Filters in pkg.
2
3
3
Carbon Filter Dimensions:
8.98 in x 6.38 in
228 mm x 162 mm
6" T connector
or 90 elbow
wall pipe strap
6" straight pipe
7
6" T connector
or 90 elbow
wall pipe strap