Measuring Blood Pressure - Beurer BC 58 Manual De Instrucciones

in the household waste. You are legally obliged to dispose of
the batteries. Dispose of them via your specialist electrical
supplier or local collec ting point for recyclable waste.
Note: Batteries containing pollutant substances
are marked as follows: Pb = Battery contains
lead, Cd = Battery contains cadmium,
Hg = Battery contains mercury.
Setting date and time
You should set the date and time without fail. Otherwise,
you will not be able to save your measured values correctly
with a date and time and to access them again later.
Tip: If you press and hold the MEM button, you can set the
values more quickly.
To set the date and time, proceed as follows:
• Move the touch screen activation switch to the ON position.
• Press the START/STOP and MEM buttons simultane-
ously, 24h begins to flash. Select 12h or 24h mode using
the MEM button. Press START/STOP to confirm your
selection. The year display will start to flash. Set the year
with the MEM button and confirm with START/STOP
• Then set the month, day, hour and minutes and confirm
each setting with START/STOP
• Pressing the START/STOP button
display off.
.
.
again will switch the
Note: In 24h mode, the date is displayed as day/month. In
12h mode, as month/day.

5. Measuring blood pressure

Please ensure the device is at room temperature before
measuring.
Positioning cuff
• Bare your left wrist, making sure that the circulation in the
arm is not restricted by any clothes etc. that are too tight.
Position the cuff on the inside of your wrist.
• Fasten the cuff with the Velcro fastening so that the upper
edge of the monitor is positioned approx. 1 cm below the
ball of your thumb.
• The cuff has to be fitted tightly around the wristbut should
not constrict it.
Important: The instrument should only be operated with the
original cuff.
19