Saving, Retrieving And Deleting Results; Error Messages/Trouble-Shooting - Beurer BC 58 Manual De Instrucciones

blood pressure as well as the value above which your blood
pressure is classified as dangerous.
The WHO classification in the display shows the range of
the measured blood pressure.
If the values for systolic and diastolic pressure are in two
different WHO ranges (e.g. systolic in the grade hyperten-
sion range and diastolic pressure in the normal range), the
WHO classification on the unit always indicates the higher
range (grade hypertension in the example described).

7. Saving, retrieving and deleting results

• The results of each successful measurement are stored
together with date and time. With more than 60 items of
measured data, the earliest items of data measured are
lost.
• Move the touch screen activation switch to the ON posi-
tion.
• Make a selection with the MEM button, and then con-
firm the desired user memory with the START/STOP but-
ton . If you press the MEM button again, the aver-
age value of all the stored measured values in the user
memory will be displayed. If you press the MEM button
again, the average value of the last 7 days for the morning
measurement will be displayed (Morning: 5 a.m. – 9 a.m.,
display ). If you press the MEM button again, the aver-
age value of the last 7 days for the evening measurement
will be displayed (Evening: 6 p.m. – 8 p.m., display
you continue to press the MEM button, the most recent
individual measured values with date and time are dis-
played in turn.
• You can delete the memory by pressing and holding the
MEM button for 3 seconds. All the values in the current
user memory are deleted after three beeps are output.
• To switch off the device, press the MEM button again or
the START/STOP button
vation switch to OFF.
• If you forget to switch off the device, it will switch off
automatically after 2 minutes.

8. Error messages/trouble-shooting

In case of faults, the
Error messages may appear if:
• systolic or diastolic pressure could not be measured (
or appears on the display)
• systolic or diastolic pressure was outside the measure-
ment range ( or
• the cuff is fastened too tightly or loosely (
appears on the display)
• the pump pressure is higher than 300 mmHg (
appears on the display)
• pumping up takes longer than 160 seconds (
on the display)
22
or push the touch screen acti-
_ message appears in the display.
appears on the display)
). If
or
appears