Prepare Measurement - Beurer BC 58 Manual De Instrucciones

Icons in the display:
1. Time and date
2. WHO classification
3. Systolic pressure
4. Diastolic pressure
5. Measured pulse
6. „Change battery" icon
7. Pump up, release air (arrow)
8. Memory display ( ), average value ( ), morning (
evening ( )
9. Cardiac arrhythmia icon
PC interface
The Beurer blood pressure monitor also allows you to trans-
fer your measured values to the PC.
To do this you require a USB cable (included in delivery) and
the Beurer "Health Manager" PC software.
The software can be downloaded free of charge from
www.beurer.com/service/download
System requirements for the Beurer "Health Manager"
computer software
1. Supported operating systems:
• Windows XP SP3
• Windows Vista SP1 or later
• Windows 7
• Windows 7 SP1
1
9
8
2
8
3
7
6
4
5
min
),
18
2. Supported architectures:
• x86 (32 bit)
• x64 (64 bit)
3. Hardware requirements:
• Recommended: at least Pentium 1 GHz or faster with at
least 1 GB RAM
• Free memory on the primary partition of at least:
– x86 – 600 MB
– x64 – 1.5 GB
• Graphic resolution from: 1024 x 768 pixels
• USB port 1.0 or later

4. Prepare measurement

Inserting battery
• Open the battery compartment lid.
• Use exclusively brand-name batter-
ies of the type: 2 x 1.5 V Micro (Alkaline
Type LR 03). Making absolutely sure
that you insert them with the correct
polarity as marked. Do not use rechargeable batteries.
• Replace the battery cover carefully.
If the battery change
urement is no longer possible and you must replace all
the batteries. Once batteries have been removed from the
device, the time must be reset. Used batteries do not belong
is continuously illuminated, meas-