nuair RevolutionAir Graffity HVLP 600W Manual De Instrucciones página 12

GB
Graffity - HVLP 600W
Paint gun operation and use
The spray can be adjusted very easily as follows:
- Completely close the adjustement screw (H - 1) turn to
the right.
- Keep pulling the trigger (H - 2) and slowly open the paint
screw (H - 1) until the correct amount of paint is obtained.
- The spray gun should be moved with a regular motion and
always kept at the same distance (from 10 to 30 cm)
depending on the adjustment and type of paint used), and
above all must always be parallel to the surface of the
object being treated (I - 1).
Warning!
Never use a circular movement: this might damage the
quality of the finish (I - 2). Release the trigger at the end of
each forward mevement and pull it again when the return
movement has started.
This will avoid any joining marks caused by a second coat,
especially for large surfaces (L).
The movemennt must be horizontal if the spray is vertical or
vertical if the spray is horizontal.
The round spray (CC) requires a greater distance from the
object to be painted. In any case make tests on a pieces of
cardboard or wood before paintig.
OTHER USES OF THE PAINTING MACHINE
By connecting the fitting to the hose the painting machine
can also be used to blow or inflate mattresses or other
inflatable objects.
PAINTING MACHINE MAINTENANCE AND CLEANING
The painting machine Graffity needs minimum maintenance.
First of all, disconnect the apparatus from the mains.
Clean the structure with a clean cloth (soaked in water or
alcohol, if necessary).
PAINT GUN MAINTENANCE AND CLEANING
The paint gun must be thoroughly cleaned immediately
after use. If the paint dries inside the gun cleaning will be
much more difficult, and it may no longer be possible use
the gun. Use the thinner (or solvent) recommended by the
paint manufacturer clean the gun in a well ventilated room.
Follow the safety instructions described.
Paint gun
- Disassemble the gun reservoir.
- Pour any residual paint into its containner and seal it so
that it can be used in the future.
- Pour the thinner (in small amounts) into the reservoir,
shake the gun lightly and atomise the trinner into a cleaning
container. Repeat the operation until the thinner being
sprayed is completely clean.
- Clean off any trace of paint, both inside and outside the
reservoir.
- Clean the gasket located under the reservoir cover.
Nozzle and needle
- Unscrew the ring (M - 1).
- Remove the butterfly nozzle (M - 2)
- Completely loosen the adjustemennt screw (M - 3)
- Remove the plain washer (M - 4).
- Completely loosen the adjustemennt screw (M - 5)
- Remove the spring (M - 6)
- Push out the needle (M - 7): it is recommended not to use
tools.
- Put all these pieces in a container and clean them using
a brush and clean thinnner.
- The inside of the gun and the hose should also be
cleaned.
- Before replacing these parts thay must be thoroughly
dried using the miltistage centrifugal blower.
Warning!
Reassemble the parts by reversing the sequence of operations
described above. In particular it is recommended to mount
the internal nozzle (M - 3) BEFORE the needle (M - 7).
12