nuair RevolutionAir Graffity HVLP 600W Manual De Instrucciones página 13

PROBLEM
The paint drips on the object
to be painted
Paint application weak or
irregular
No paint coverage
For safety reasons and to ensure correct operation, the reservoir is not hermetically sealed.
Even after it is completely closed, a small flow of air may still be present.
Power supply Rated power
230 V
600 W
50 Hz
Graffity - HVLP 600W
TROUBLESHOOTING - CAUSES AND SOLUTIONS
CAUSE
Product too diluted
Sparay adjustemennt
Movement too slow
Gun trigger remains pulled
Gun distance
Paint too duluted
Sparay adjustemennt
Movement too fast
Gun clogged
Gun distance
Paint not thinned enough
Paint too thick, viscosity
too high
Gun clogged
Hose burst or broken
Air filter clogged
Col grainy paint
Reservoir poorly closed
Working
Air intake
pressure
0,15 - 0,35 bar 1650 l/min
SOLUTION
Add undiluted product
Reduce the paint flow by tightening the screw (H - 1)
Move the gun faster
When reversing the movement, let go of the trigger
Increase the distance between gun and the object
Add thinner
Increase the amount of paint by using the screw (H - 1)
Move the gun more slowly
Clean the gun. Clean the internal nozzle ( (M - 3) with
a non-metallic object
Decrease the distance between gun and the object
Add thinner
Check the viscosity of the product
Clean the gun. Clean the internal nozzle ( (M - 3) with
a non-metallic object
Change the hose
Change the filter
Filter the paint, if necessary, using a filter or a screen
Clean the gasket and close the reservoir
Pipe length
190 cm
13
GB
Spray gun
Weight
tank capacity
~ 1 L 3,2 Kg