Tool Specifications; For Your Safety; Noise/Vibration Information; Machine Elements - Bosch Rotocut Instrucciones De Servicio

Euro • Printed in USA • BA 2 610 998 773 • Rotocut • GB • OSW 08/00
Rotocut - Buch Seite 1 Dienstag, 15. August 2000 10:23 10

Tool Specifications

Rotocut
Part number
Rated power*
No-load speed
Collet chucks Ø
Collet chucks Ø
Weight (without optional
extras) approx.
Safety class
* The values given are valid for nominal voltages [U] of 230/
240 V. For lower voltages and models for specific countries,
these values can vary.

Noise/Vibration Information

Measured values determined according to
EN 50 144.
The A-weighted noise levels of the machine are
typically: sound pressure level: 79 dB (A); sound
power level: 92 dB (A).
Wear ear protection!
The typical hand/arm vibration is below 2.5 m/s

Machine Elements

1 Auxiliary handle
2 Open-ended spanner (SW 16)
3 Spindle lock button
4 Screwed cap
5 Collet chuck 3.2 mm (1/8")
Collet chuck 6.4 mm (1/4")
6 Knurled screw
7 Adjustable base plate
8 Extractor connection (for flexible tube
Ø 19 mm)
9 On/Off switch
10 Adjustable foot plate
11 Circular cutter
12 Hollow
13 Metal projection
Not all of the accessories illustrated or described are
included as standard delivery.
0 601 638 1..
450 W
30 000 RPM
3.2 mm (1/8")
6.4 mm (1/4")
1.2 kg
/ II
2
.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Insert the mains plug only when the machine is
switched off.
Always direct the cable to the rear away from
the machine.
Do not work with materials containing asbes-
tos.
Keep hands away from the rotating cutting tool.

For Your Safety

Working safely with this machine
is possible only when the operat-
ing and safety information are
read completely and the instruc-
tions contained therein
strictly followed. In addition, the
general safety instructions in the
enclosed booklet must be fol-
lowed. Before using for the first
time, ask for a practical demon-
stration.
Pull the mains plug.
If the mains cable is damaged or cut
through while working, do not touch
the cable but immediately pull the
mains plug. Never use the machine
with a damaged cable.
Damage.
When cutting in corners and walls,
examine the place to be treated be-
forehand, making sure that there
are no concealed electric cables,
gas or water conduits, e.g. use a
metal detector.
Wear protective glasses and ear
protection.
Wear a dust protection mask.
Danger of injury.
Sharp application tool.
English - 1
are