4. Use the rotary knob to set the desired roasting time between 10 sec-
onds and 60 minutes.
5. Press the START button to start operation.
NOTE:
• The change of program is indicated by an acoustic signal.
• This function is not possible with the automatic and defrost pro-
grams.
Special Functions
Auto Start (Timer-Function)
The maximum time-delay is 23 hours and 59 minutes.
NOTE:
• First set the clock! Otherwise you may not use this function.
• When using auto start, the defrost function is not available. This
program setting does not support quick start cooking.
Example: It is 10:45 h. You want to program the microwave so that it
operates at maximum power for 7 ½ minutes at 14:20. Pro-
ceed as follows for automatically starting the microwave:
Step
Button
1
MICRO
2
Hold down the TIME.CLOCK
3
button for 3 seconds
4
5
TIME.CLOCK
6
7
TIME.CLOCK
NOTE:
• The Timer function is activated when the " " symbol flashes in the
display. A long beep confirms the end of the settings.
• During this programmed setting the functions of the controls are
blocked (except: TIME.CLOCK, STOP / CANCEL and START).
• If you wish to display the start time again, press the TIME.CLOCK
button.
• In order to deactivate the automatic start time, press the STOP /
CANCEL button.
• When the pre-set time has been reached, the microwave will start
operation. A beep indicates the start.
• If you wish to start the program earlier, then press the START but-
ton. The program begins based on the previously selected settings.
WARNING: Risk of Fire!
• Always supervise the appliance during operation.
• When using the time-delay function, set the time in such a way that
the appliance will be operating under proper supervision.
• Do not operate the microwave empty. If you want to take out the
food before the program has finished, you have to cancel the pro-
gram by pressing the STOP / CANCEL button.
62
PC-MWG1204_IM
Display
(Power)
(Cooking time)
(Current time)
(Setting the hours)
(Confirmation of hour)
(Setting the minutes)
(Current time)
Locking (Child-proof Lock)
• Press and hold the STOP / CANCEL button for 3 seconds to lock the
appliance. You will hear a signal tone. The locked condition is shown
in the display by "
". The control panel function is blocked.
• Press and hold the STOP / CANCEL button again for 3 seconds to
unlock. You will hear a signal tone.
Display Function
If you press the MICRO button during operation, the operating mode will
be displayed for 1 - 2 seconds.
Cleaning
WARNING:
Turn the microwave off and remove the mains plug.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any acidic or abrasive detergents.
• Do not use a metal scraper to clean the viewing window. The sur-
face could be scratched and the glass could possibly break.
Interior
• Keep the interior of the oven clean. Splashes and overflowing liquids
on the walls of the oven can be removed with a damp cloth. If the
oven is very dirty a mild detergent can also be used.
• Wipe off the viewing window on the inside and outside with a damp
cloth and remove splashes and stains from overflowing liquids regu-
larly.
External Walls
• The external walls of the microwave should only be cleaned with a
damp cloth. Please ensure that no water enters the openings in the
housing and therefore inside the appliance.
• Open the microwave door before cleaning the control panel in order
to avoid accidentally switching on the appliance.
• For cleaning the reflecting glass front, it is best to use a fine microfi-
bre cloth.
Accessories
Clean the grill grate with hot rinse water with a little bit of dishwashing
detergent after each use.
Odours
In order to remove any unpleasant odours that may emanate from the
microwave, place a dish filled with water and lemon juice that is suitable
for microwave use in the oven and heat it for approximately 5 minutes.
Then wipe out the oven with a soft cloth.
Oven Light
If you need to replace the lighting in the oven, please contact a special-
ist workshop near you.
15.10.19