Getting Started - Hama TH-140 Instrucciones De Uso

Warning – Batteries
• Immediately remove and dispose of dead batteries from the product.
• Only use batteries (or rechargeable batteries) that match the specified
type.
• Do not mix old and new batteries or batteries of a different type or make.
• When inserting batteries, note the correct polarity (+ and - markings)
and insert the batteries accordingly. Failure to do so could result in the
batteries leaking or exploding.
• Do not overcharge batteries.
• Keep batteries out of the reach of children.
• Do not short circuit the batteries/rechargeable batteries and keep them
away from uncoated metal objects.

4. Getting started

Open the battery compartment cover (6), remove the contact breaker and
then close the battery compartment cover (6). The thermometer is now
ready for use.
4.1 Base (7)
To stand the product, the base (7) must be pulled out beneath the battery
compartment cover (6) and folded over.
5. Operation
5.1Setting the date/time/time format
• After removal of the batteries' contact breaker, the normal time is displayed
in 12-hour format and a melody signals that the product is ready for use.
(Normal time mode)
• Press the UP (4) or DOWN button (5) to switch between the 12 and 24-hour
formats.
• Use the UP button (4) or DOWN button (5) to select the desired format.
• Then press the SET button (3) to make the following settings:
• Hours
• Minutes
• To select individual values (hours/minutes), press the UP button (4) or the
DOWN button (5) and confirm each selection by pressing the SET button (3).
• Then complete the process using the MODE button (2).
• To change the set time, you must press the SET button (3) for 2 seconds; you
can then continue as described above.
• Pressing the MODE button (2) twice takes you to the date/year/month
settings. To enter the values, hold the SET button for approximately 3
seconds.
• To select individual values, press the UP button (4) or the DOWN button (5)
and confirm each selection by pressing the SET button (3).
• To confirm all your settings and return to the start display, you must press the
MODE button.
3