Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Position of
Speed
speed
change lever
1
Low
2
High
To change the speed, switch off the tool first. Select
the "2" side for high speed or "1" for low speed but high
torque. Be sure that the speed change lever is set to the
correct position before operation.
If the tool speed is coming down extremely during the
operation with "2", slide the lever to the "1" and restart
the operation.
Selecting the action mode
CAUTION:
Always set the ring correctly to
your desired mode mark. If you operate the tool
with the ring positioned halfway between the
mode marks, the tool may be damaged.
CAUTION:
When you change the position
from "
" to other modes, it may be a little dif-
ficulty to slide the action mode changing ring. In
this case, switch on and run the tool for a second
at the "
" position, then stop the tool and slide
the ring to your desired position.
Adjusting the fastening torque
1
1. Action mode changing ring 2. Adjusting ring
3. Graduation
4. Arrow
The fastening torque can be adjusted in 21 steps by turning the adjusting ring. Align the graduations with the arrow
on the tool body. You can get the minimum fastening torque at 1 and maximum torque at 21.
Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which
torque level is required for a particular application. The following shows the rough guide of the relationship between
the screw size and graduation.
Graduation
Machine screw
Wood
Soft wood
screw
(e.g. pine)
Hard wood
(e.g. lauan)
Torque
Applicable
operation
High
Heavy load-
ing operation
Low
Light loading
operation
2
3
4
1
2
3
4
5
6
M4
–
–
1
1. Action mode changing ring 2. Adjusting ring
3. Graduation
This tool has three action modes.
•
Drilling mode (rotation only)
•
Hammer drilling mode (rotation with
hammering)
•
Screwdriving mode (rotation with clutch)
Select one mode suitable for your work. Turn the
action mode changing ring and align the mark that you
selected with the arrow on the tool body.
7
8
9
10
11
12
M5
ɸ3.5 x 22
ɸ4.1x 38
ɸ3.5 x 22
4. Arrow
13
14
15
16
17
18
M6
–
ɸ4.1x 38
2
3
4
19
20
21
–
ENGLISH
7
Publicidad
Tabla de contenido
