Led Displays At A Glance - WMF LONO Instrucciones De Uso

LED displays at a glance

Colour LED
Start / Stop button
illuminates white
flashes white
illuminates green
flashes blue / white
flashes blue
illuminates blue
Start-up
Prior to the first use and after the device has not be operated for an extended period
of time, carry out a boiling process with fresh water without coffee grounds. Fill the
tank to the 10-cup mark (version with teapot) or to the 8-cup mark (version with
vacuum jug), as otherwise the pot can overflow.
To prepare coffee
You can remove this in order to easily fill the water tank (5). Open the water tank (5)
by removing the lid. Only pour cold water into the tank (5). The water level indicator
is for the amount of fresh water that is needed to brew the desired number of cups
per 125 ml coffee.
Swing out the filter (4) to fill with ground coffee. Place the paper filter of the 1 x 4
size into the filter, but fold the stamped edge before doing so. The paper filter should
not protrude over the edge of the filter, which is why it should be pushed down
slightly with your hand.
Fill with the required amount of ground coffee. Depending on personal taste, you
can figure about 5-7 g of medium-fine ground coffee per cup. If it is ground too
finely, the filter can overflow.
Then close the swing filter (4). It will audibly click into place.
Insert the mains plug into the socket and push the Start / Stop button (1). The LED
illuminates white and the preparation begins.
You can cancel the preparation at any time by pressing the Start / Stop button (1).
Wait a few minutes until all of the coffee has run into the pot. After removing the
pot, a drip-stop prevents coffee from dripping.
14
Coffee machine
action
Coffee preparation (with aroma
function) is running
Aroma function selected
Preparation completed
(only version with vacuum jug)
Preparation completed, keep-
warm function active
(only version with vacuum jug)
Scaling indicator
Descaling programme selected
Decalcification programme active