WMF LONO Instrucciones De Uso página 15

WMF Aroma Perfection
If you would like to prepare a strong aromatic coffee, you can activate the aroma
function WMF Aroma Perfection. It is particularly recommended for preparing
small amounts. To do so, push the Aroma button
(2) just before you begin the
brew process with the Start / Stop button (1). The LED of the Start / Stop button (1)
will flash white.
Note: If you wait longer than approximately 3 seconds to start the brewing process,
then the Aroma function deactivates again. The LED of the Start / Stop button (1)
turns off.
Please note that the preparation time takes a slightly longer.
Keep-warm function
(only version with teapot)
In order to keep the finished brewed coffee at a serving temperature, your device is
equipped with a keep-warm function. After the preparation is complete, the keep-
warm function activates automatically and the Start / Stop button (1) illuminates
green. The keep-warm time is 40 minutes. Then the device automatically switches off
and the Start / Stop button (1) turns off.
You can deactivate the keep-warm function at any time by pressing the Start / Stop
button (1).
Automatic shut-off
(only version with vacuum jug)
After being switched on, the automatic shut-off ensures that the device does not
overheat. Only once the water has completely passed through does the device switch
off and the Start / Stop button (1) illuminates green for 2 minutes. The device
switches off after another 2 minutes approximately and the Start / Stop button (1)
turns off.
It is possible to shut off the coffee maker early by pressing the start / stop button (1).
This could be necessary if you accidentally start the coffee machine without water.
It is necessary to wait for a few minutes before you add more water into the hot
device. Allow the coffee machine to cool beforehand.
Information about the Cromargan® vacuum jug
(only version with vacuum jug)
The pot is designed as a serving pot and best keeps the content warm when it is
full. The keep warm time can be significantly reduced if it is only partially full or has
residual amounts. It is best if the pot is rinsed with hot water before preparation.
For technical reasons, the seal from the brewing lid is not 100% tight so that it can
be easily opened, even after the coffee cools down. To close, only slightly tighten the
lid. Only use the filled pot standing upright.
To pour, press the pour button on the handle.
To open the pot, turn the lid slightly counter-clockwise. After closing the lid, ensure
that the pour button lines up with the pot handle.
The double-walled Cromargan® pot is absolutely break-proof. Nevertheless, it should
be protected against mechanical stresses.
Rinse the pot regularly. If iron particles from water accumulate on the Cromargan®
surface, they can create pitting at those points. Therefore, remove these deposits
immediately with a stainless steel cleanser.
15