WARNING: Risk of injury!
• Appliances can be used by persons with reduced physical, senso-
ry, or mental capabilities or lack of experience and / or knowledge,
if they are supervised or have been instructed concerning safe
use of the appliance and understand the hazards involved.
• Do not try to repair the appliance on your own. Always contact an
authorized technician. If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent or similarly quali-
fi ed persons in order to avoid a hazard.
CAUTION:
Do not immerse the device into water for cleaning. Follow the in-
structions that we provide in the chapter "Cleaning".
• Do not manipulate any of the safety switches.
• Only process foodstuffs with this appliance.
• Misuse of the appliance for other purposes may cause injury.
Overview of the Components / Delivery Scope
1 Swivel arm
2 Lever for lowering / raising the arm
3 Control knob
4 Motor housing
5 Whisk
6 Mixing bowl
7 Protective disk
8 Drive shaft with splint
9 Transparent splash guard lid with replenishing opening
10 Mixing hook
11 Kneading hook
Unpacking the Appliance
1. Remove the packaging of the appliance.
2. Remove all packaging material such as plastic fi lm, fi ller
material, cable ties and box packaging.
3. Check that all parts are in the box.
4. If the packaging content should be incomplete or if dam-
ages should be noticeable, do not operate the appliance.
Return it to the distributor immediately.
KM1394CB_IM
NOTE:
Dust or production residues may still be found on the
appliance. We recommend that you clean the appliance as
described under "Cleaning".
Electric Connection
Check that the mains voltage to be used matches the
voltage of the appliance. Refer to the rating label for detailed
specifi cations.
Operation
1. Opening the swivel arm: Swivel the lever in direction
and hold it in that position. Move the swivel arm by hand
to the top position and release the lever.
2. For use of the kneading hook (11) or the mixing hook (10),
fi rst attach the protective disk. It prevents contact of
dough with the drive shaft.
Hold the disk like a bowl. Insert the kneading hook (11) or
the mixing hook (10) from below through the recess in the
disk opening and tighten it by a quarter turn to the left.
31
27.09.16