Makita XRU09 Manual De Instrucciones página 10

Ocultar thumbs Ver también para XRU09:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fit the grip onto the pipe and tighten it with two hex
bolts. Make sure that the grip is located further than the
hanger.
Installing the guard
WARNING:
Never use the tool without the guard illustrated
in place. Failure to do so can cause serious
personal injury.
CAUTION:
Take care not to injure yourself on the cutter for
cutting the nylon cord.
2
1
015792
Align the clamp on the pipe with the protector. And
tighten them with bolts.
Installing nylon cutting head
CAUTION:
If the nylon cutting head accidentally impacts a
rock or hard object during operation, stop the
tool and inspect for any damage. If the nylon
cutting
head
immediately. Use of a damaged cutting tool could
result in serious personal injury.
NOTICE:
Be sure to use genuine Makita nylon cutting head.
Turn the tool upside down so that you can replace the
nylon cutting head easily.
4
015392
Insert the hex wrench through the hole on the motor
housing and rotate the receive washer until it is locked
with the hex wrench. Place the nylon cutting head onto
the threaded spindle directly and tighten it by turning it
counterclockwise. Remove the hex wrench.
To remove the nylon cutting head, turn it clockwise while
holding the receive washer with the hex wrench.
1. Cutter
3
2. Clamp
3. Bolt
is
damaged,
replace
1. Nylon cutting
1
head
2. Metal guard
3. Receive washer
2
4. Hex wrench
3
Hex wrench storage
015399
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
OPERATION
Correct handling of tool
Correct posture
WARNING:
Always position the tool on your right-hand
side. Correct positioning of the tool allows for
maximum control and will reduce the risk of
serious personal injury caused by kickback.
Be extremely careful to maintain control of the
tool at all times. Do not allow the tool to be
deflected toward you or anyone in the work
vicinity. Failure to keep control of the tool could
result in serious injury to the bystander and the
operator.
it
015394
MAINTENANCE
WARNING:
Always be sure that the tool is switched off
and battery cartridge is removed before
attempting
maintenance on the tool. Failure to switch off
and remove the battery cartridge may result in
serious personal injury from accidental start-up.
NOTICE:
Never use gasoline, benzine, thinner, alcohol or
the like. Discoloration, deformation or cracks may
result.
10
1. Hex wrench
1
to
perform
inspection
or

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Xt331ptXt331ptxXt277ptxXru09z

Tabla de contenido