Description - Hilti ST 1800 Manual De Instrucciones

2. Description

2.1 Use of the tool as directed
The ST 1800 is a hand-held, electric mains-powered tool
for driving screws used to fasten sheet metal in metal
construction applications.
It is used to drive or remove the recommended metal
en
construction screws in the applicable materials.
The working environment may be a construction site of
any kind where metal construction work is taking place.
Use of a screw magazine is possible and provision has
been made for this (SDT 25).
Only the specified screwdriving bits, magazine and acces-
sories may be used with the tool. The general safety pre-
cautions listed in the operating instructions must be
observed.
The tool is intended for professional use.
The tool may be operated, serviced and repaired only by
authorized, trained personnel. This personnel must be
informed of any special hazards that may be encoun-
tered.
2.2 Main applications / torque settings
Application
Sheet metal on
sheet metal
Sheet metal on
steel profile
Sheet metal on
steel beam
Sheet metal on
wood
Fiber-cement
board on
steel profile
Fiber-cement
board on
steel beam
3. Accessories and insert tools
Scaffold hook
Belt hook
Depth gauge
Depth gauge
Hex. sockets
Decking tool
Bits and bit holders
10
Printed: 08.07.2013 | Doc-Nr: PUB / 5070703 / 000 / 01
Screw type / diameter in mm Torque setting
S-MD / 4.2
S-MD / 4.8
S-MD 51 + S-MD 21 / 5.5
S-MD 53 + S-MD 23 / 5.5
S-MP 52 / 6.3
S-MD 55 + S-MD 25 / 5.5
S-MP 53 / 6.5
S-MP 53 / 6.5
S-FD 03 / 6.3
S-FD 05 / 6.3
Fiber-cement
board on wood
Sandwich panel
on steel profile
Sandwich panel
on steel beam
Sandwich panel
on wood
The above settings are intended as an approximate guide-
line. They result from evaluation of the characteristic
curves for the torque clutches of tools tested in quality
assurance tests and from torque values obtained from
the corresponding screw tests.
" hexagon socket
Chuck: 1 /
4
Operating controls
Control switch with lockbutton
Forward / reverse pushbutton
Torque adjusting ring
Depth gauge adjusting ring
Items supplied as standard equipment
1–2
– ST 1800 electric screwdriver
1–8
– S-GT17 depth gauge (for screws with sealing
8–13
washers of up to 17 mm diameter)
6–11
– Operating instructions
4–12
– Toolbox or cardboard box (depending on version)
2–7
8–14
14 – max.
6–12
12–15
S-GT 23 for screws with sealing washers of up to
23 mm in diameter
S-GU13 for bit holder and bit (PH, PZ, TX etc.)
Sockets for hex. screws (7, 8, 10, 12,
SDT25 for serial fastening applications
TX, PH and TX bits; S-BH bit holder
S-FD 01 / 6.5
S-CD 63 / 5.5
S-CD 65 / 5.5
S-CDW 61 / 6.5
",
1 / 5 /
4
12 – max.
2–7
2–9
5–8
", ")
3 /
16 8