Carrera RC Spider Fox Instrucciones De Montaje página 14

Preparing the first flight
This checklist does not replace the contents of the operating instructions.
Although it can be used as a quick-start-guide we strongly advise to first read the
operating instructions in detail before you proceed.
• Check the contents of the package
• Connect the charger to the power socket
• Charge the li-ion-battery as described in the section „Charging the li-ion battery".
• Fit four AA batteries in the controller, making sure their polarity is correct.
• Look for a suitable environment for flying
• Place the helicopter on a flat surface
• Switch on first the helicopter and then the controller.
• Check the control system
• Make yourself familiar with the control system
• Trim the helicopter if necessary as described on P. 16, so that when hovering,
the helicopter no longer moves from the spot without the controls being touched.
• Fly the model
• Land the model
• Switch the model off
• Always switch off the remote control last
Checklist for flight preparation
This checklist does not replace the contents of the operating instructions.
Although it can be used as a quick-start-guide we strongly advise to first read the
operating instructions in detail before you proceed.
• Connect the plug-in connection at the model and switch on the model at the
ON/OFF switch
• The LED in the helicopter now flashes in rhythmically-accelerating sequence.
• Switch on the controller at the ON/OFF switch. While connecting, the controller
emits a signal tone.
• Place the charged helicopter on a flat surface.
• Allow the helicopter a few moments until the system is correctly initialised and
is ready for operation.
• The LED in the helicopter is not lit continuously and the controller is no longer
emitting its signal tone.
• The helicopter is now ready to be flown.
• If the helicopter fails to display any function, connect the model with the
controller as necessary, as shown below.
• Fly the model
• Land the model
• Switch the model off at the ON/OFF switch and unplug the connection in the
helicopter.
• Always switch off the remote control last
Frequency bind between
model and remote control
1
ON
ON
• Connect the plug-in connection at the model and switch on the model at the ON/OFF
switch.
• The LED in the helicopter now flashes in rhythmically-accelerating sequence.
• Switch on the controller at the ON/OFF switch. While connecting, the controller
emits a signal tone.
• Place the charged helicopter on a flat surface.
• Allow the helicopter a few moments until the system is correctly initialised and is
ready for operation.
• The control LED now lights continuously once again, indicating that the connection
is ended.
Changeover between
Beginner / Advanced mode
1
When controller and helicopter are initially switched on, the model is in „Beginner"
mode.
To change between Beginner and Advanced mode when the controller and helicopter
are switched on, press the right-hand joystick in vertically from above.
The changeover can also be made while the machine is in flight. When changing over
into Advanced mode, you will hear a single „beep" signal and when changing into
Beginner modus a „beep-beep" will be heard.
The helicopter reacts more sensitively in Advanced mode to your commands on
the controller than it does in Beginner mode.
Note: you should first practice flying with the helicopter in Beginner mode until
you are fully in control of the model. Only then should you switch over to Advanced
mode. The helicopter will react in Advanced mode more sensitively to your commands
on the controller!
14
The Carrera RC helicopter and the
remote control are frequency bound at
purchase. Should there occur any prob-
lems with the communication between
the Carrera RC helicopter and the
remote control at the beginning, please
carry out a new frequency bind.