Tabla de contenido
Publicidad
IV Long storage of mini-tiller
If the tiller need be stored for a long time, the following measures should be taken to prevent rust and
erosion.
1. Seal up and store gasoline engine as per requirements in the manual of gasoline engine.
2. Clean dirt and slime on the outer surface,
3. Drain lubricant from the transmission box and fill it with new lubricant.
4. Apply anti-corrosion oil on unpainted part of the non-aluminum-alloy surface.
5. Keep the product in a well ventilated, dry and safe indoor place.
6. Properly keep the tools, quality certificate and operation manual attached to the machine.
If the engine can't be started, please check
1. Whether the engine switch is in the ON position,
2. Whether there is enough lubricant in the machine,
3. Whether fuel valve is in the ON position,
4. Whether there is fuel in the fuel tank,
5. Whether fuel can be delivered into carburetor, to check this, the user can loosen drain bolt of
carburetor and set the fuel valve to the ON position.
Warning! : If any fuel is spilled out, thoroughly remove it and let it dry up before checking spark plug
or starting the engine, because fuel spilled out and its vapor may cause a fire.
6. Whether the spark plug can spark.
a. Pull off the spark plug cap, remove dirt from it, then detach the spark plug.
b. Fit spark plug cap over the spark plug.
c. Contact the metallic case of spark plug to engine's cylinder head. Slightly pull the starter to
check if sparks are produced. If so, refit the spark plug and start the engine.
7. If the engine still cannot start, please repair it at an authorized distributor's shop.
Chapter VIII Trouble shooting
Tappo
serbatoio
16
Publicidad
Tabla de contenido
