Status Adjustment Of The Tiller - Stiga RC 685 Manual De Instrucciones

3. Checking the air filter in oil bath
Warning! Never try to run the engine without the air filter,
if so, the engine will be worn more quickly.
– Loosen the wing nut and remove the filter
cap (See fig. 4A).
– Top up with oil as far as the indicated level
(Oil type: SAE 15W-40).

(2) Status adjustment of the tiller

1. Adjustment of handle frame
Note: Before adjusting height of handle frame,
please put the machine on a flat horizontal
ground to prevent it from accidental falling.
● Loosen the lifting handle and select the hole in
an appropriate position, then adjust the handle's
cross bar to as high as user's waist, then turn the
lifting handle to tighten it (See Fig.5).
2. Adjustment of tilling depth
● By adjusting height of damping lever, tilling depth can be
adjusted. Specifically, adjusting the lever downward will
increase tilling depth, and adjusting it upward will decrease
tilling depth. (See Fig.6)
3. Adjustment and use of clutch
Note: Before using the clutch, lower the engine speed.
● By "engage " and "disengage "of the clutch, the user can
control output of engine's power.
● When the user holds tight the clutch lever, the clutch is engaged and transmits engine power to
the tiller and tilling blades begin to rotate. (See Fig.7)
Figure 4a
6