Makita 6922NB Manual De Instrucciones página 5

OPERATION
Bolt installation
Slip the tool onto the bolt so that the inner sleeve com-
pletely covers the bolt tip.
CAUTION:
• Be careful when fitting the sleeve onto the bolt tip.
Striking the tip can damage it so that it will no
longer fit inside the sleeve properly.
Keep forward pressure on the tool while sliding it further
forward until the outer sleeve fits completely over the nut.
If the tool fails to fit completely over the nut, twist the tool
slightly right and left while pushing forward.
Pull the switch trigger. The outer sleeve turns to begin
tightening the nut.
004988
1. There should be
1
no gap between
the outer sleeve
and the tool.
2. Outer sleeve
3. Screw
2
3
004989
1. Inner sleeve
1
2. Bolt tip
2
004990
1. Outer sleeve
1
2. Nut
2
When the specified torque is attained, the bolt tip will be
sheared at its notched portion. The bolt tip will remain
inside the inner sleeve.
Release the switch trigger and withdraw the tool in a
straight line.
Press the tip ejector (tip lever) to eject the bolt tip from
the tool. Catch the sheared bolt tips to prevent them from
falling dangerously below. Keep the tips off of the ground,
floor, walkways, etc. to prevent injury from tripping or fall-
ing.
1
5
004991
1. Notched portion
1
2. Bolt tip
2
004992
1. Outer sleeve
1
004993
1. Bolt tip
004994
1. Tip ejector (Tip
lever)
1