Troubleshooting Tips ...
Problem
Oven will not start
"KEYPAD SHORTED--- SERVICE MAY
BE NEEDED" appears on display
"FOOD" appears on display along with
beeping
"LOCKED" appears on display
FEDERAL COMMUNICATIONS COMMISSION (U.S.A.)
RADIO FREQUENCY INTERFERENCE STATEMENT
This equipment generates and uses ISM frequency energy
and if not installed and used properly, that is in strict
accordance with the manufacturer's instructions, may
cause interference to radio and television reception. It has
been type tested and found to comply with limits for an
ISM Equipment pursuant to part 18 of FCC Rules, which
are designed to provide reasonable protection against
such interference in residential installation. However,
there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause
interference to radio or television reception, which can be
determined by tuning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following:
14
Before you call for service
Possible Causes
Microwave oven power cord is not
plugged into an electrical outlet.
Door is open.
Wrong operation is set.
A key has been activated for more than
60 seconds. Press Stop/Cancel to clear
the display. This can happen if liquid is
on the control panel.
Key press has been detected and the
door has not been opened within 5
minutes of the last key press.
The control has been locked.
• Reorient the receiving antenna of radio or television.
• Relocate the Microwave oven with respect to the receiver.
• Move the microwave oven away from the receiver.
• Plug the microwave oven into a different outlet so that
the microwave oven and receiver are on different branch
circuits.
The manufacturer is not responsible for any radio of TV
interference caused by unauthorized modification to
this microwave oven. It is the responsibility of the user to
correct such interference.
What to do
Plug into a grounded 3 prong outlet.
Close the door and try again.
Check instruction.
Dry the control panel thoroughly after
cleaning.
Open and close the door and reattempt
new cycle.
Press and hold Stop/Cancel for 3
seconds. Two beeps will sound and then
"UNLOCKED" will appear on display.
49-2000373 Rev. 2