Secure Dishwasher; Complete Installation - Kenmore 66513463K900 Instrucciones De Instalación

Secure dishwasher in cabinet opening
Tip Over Hazard _
Do not use dishwasher until completely installed. _
Do not push down on open door.
Doing so can result in serious injury or cuts.
1. If you have not already done so, open dishwasher door
and place towel over pump assembly and spray arm of
dishwasher.This will keep screws from falling into
pump area if you unintentionally drop them when
securing dishwasher to countertop.
2. Check that dishwasher is still level and centered side to
side in the opening.
3. Secure dishwasher to countertop or sides of cabinet
with two, #10 x 1/2" Phillips-head screws.The
dishwasher must be secured to keep it from tipping
when door is opened.
L
screw to countertop
OR
screw to
side cabinet
4. Open door about 3 inches (7.6 cm) and check that space
between inner door and tub is equal on both sides. If
spacing is not equal, loosen bracket screws and shift
tub.Tighten bracket screws.
5. If using a countertop attachment to secure dishwasher,
check that top of door does not contact screws, brackets,
or countertop. If it does, dishwasher must be lowered
and re-leveled.
Z
8,
/
If securing with a side attachment, check that sides of
door do not rub against the screw heads. If they do,
dishwasher must be re-centered.
Remove towel from dishwasher.
Reinstall the lower dishrack.
Complete installation
1. Check that grounding clip is attached to the lower
panel.
2, Place the lower panel behind the access panel. Some
models have insulation on the access panel which must
fall behind the insulation on the lower panel.
grounding
clip
3, Hold the two panels together and place them against
dishwasher leg.
4, Reinstall the screws through the holes in the access
panel and the slots in the lower panel. Install right side
screw first.
/ /
5,
6,
J
J
J
Check that the lower edge of the lower panel contacts
the floor.
Tighten the screws.
13