SOLAC CVG9610 Instrucciones De Uso página 13

BOOK_CVGECO.book Page 13 Monday, April 22, 2013 10:25 AM
• The first few times you use it, some small white particles may be released; these
are totally harmless and do not stain. This is a relatively normal result of the
manufacturing processes.
• Do not spray "vertical" steam on a garment hanging in the wardrobe or on a person.
Vertical ironing must be done with the garment on a hanger and away from other
garments, elements or persons.
• When you finish ironing, always empty the water from the tank. If you want to drain it
while ironing, always unplug the appliance from the mains first.
• To disconnect the CVG, never pull on the power cord, take out the plug.
q
IMPORTANT: When you want to dispose of the appliance, NEVER throw it in the
rubbish. Instead, go to your closest CLEAN POINT or waste collection centre for
subsequent treatment. In this way, you will be contributing to looking after the
environment.
Before disposing of your used appliance, you should make it visibly unserviceable
and have it disposed of according to current national legislation. Ask your
Distributor, Town Council or Local Authority for detailed information.
MAIN COMPONENTS AND ACCESSORIES
1 Water tank cap
2 SUPERSTEAM outlet
3 SUPERSTEAM pushbutton
4 Water tank
5 Removable anti-limescale filter
6 Non-slip base
7 Temperature selector.
BEFORE STARTING TO IRON
Make sure you have removed the soleplate protector before starting to iron.
1 With your CVG unplugged, open the filler cap turning it upwards (fig.2).
Due to the high level of water hardness in most areas, Solac recommends that you
always use distilled or demineralised water for ironing. You will thus guarantee that
your CVG stays in perfect condition for as long as possible. If you cannot find distilled
water for any reason, be sure to use water that is low in minerals (soft). Remember
that damage caused by the effects of limescale and sludge is not covered in the
warranty.
Do not put any type of scale remover solvents or products in the water tank. Do
not use perfumed or ironing water either. These products can damage the
interior of the steam generation system. If the CVG is damaged in this way, it will
not be covered by the warranty.
2 Use a beaker (not included) to fill the water tank without exceeding the maximum level,
keeping the CVG in a vertical position. When the tank is full, close the cap (1).
Keep the water-filling hole lid (1) closed during operation.
3 Check the garment to be ironed to see if it has a label that indicates the ironing
temperature.
MAIN COMPONENTS AND ACCESSORIES
8 Steam pushbutton and steam
pilot light average (20 g/min)
9 Steam pushbutton and steam
pilot light average (40 g/min)
10 SUPERSTEAM and Stand-by
pilot light
11 Temperature pilot light
en
13