Cleaning & Maintenance - Silk’n Lipo H5001 Manual Del Usuario

Changing the EMS level:
7.
To increase: Short press the + button as many times as you need to
y
set to the EMS level that is comfortable for you. The operating light
blinks more quickly as you increase the EMS level.
If you long press the + button, the EMS level will still only increase
a
by one increment.
To reduce: Short press the - button as many times as you need (see
y
section "4.2 Controls and settings").
Long pressing the - button, sets the EMS level back to zero.
a
Treat each area for 15 minutes. Keep the treatment unit in place,
8.
and the device on for up to 15 minutes. Every few minutes you will feel a
vibration. The vibrations are a normal part of the treatment routine. At the
end of 15 minutes, you will feel 3 vibrations, no more energy will be emitted
and the device will shut down automatically.
To switch off the device before 15 minutes, long press the control
a
button. You will feel 2 vibrations, then the device will shut down.
9. If you want to treat another area (next to the area you have just treated
or another part of your body), wet the electrode pad, and move the
treatment unit to the next location.
Try to avoid gaps and overlaps.
a
If you move the device to another part of your body and the
a
treatment unit is not in good contact with the skin, the EMS level
will revert to zero. If this happens, make sure the treatment unit is
in good contact with the skin, then short press the control button
to start the device again, and then the + button to increase the EMS
level.
8. Cleaning & maintenance
8.1 Cleaning the treatment units & charging cradle
We recommend that you clean the treatment unit after each use, and the
stand/charging cradle once a month.
17
EN